Panasonic KX-HNC710W Installation Manual page 19

of anchor appropriate for the
installation location and
materials.
R Do not install on gypsum board
or concrete blocks.
Installing the camera
1
Open the interface cover (A),
and then slide the power slide
switch to ON (B).
2
Close the interface cover (C).
3
Secure the safety wire ring to
the camera nut of the camera
using a driver (D), and then
pass the safety wire through
the ring of the safety wire ring
(E).
For assistance, please visit http://shop.panasonic.com/support
HNC710_(en_en)_0207_ver.110.pdf
4
5
2
1
3
19
Important:
R Make sure to close the
interface cover securely.
Water resistance cannot
be assured if the interface
cover is open.
4
Drive the wall mounting
screws into the wall.
1 Longer than 25 mm (1 inch)
2 Space 2.8 mm (
1 2
Note:
R Use the following template
when determining the
location of the screw holes.
25.4 mm
(1 inch)
5
Mount the wall mounting
adaptor to the wall. Next,
attach the safety wire to the
wall, and then attach the
camera to the wall mounting
adaptor.
1 Wall mounting screws
2 25.4 mm (1 inch)
Setup
1
/ inches)
8
19
2018/02/07 20:11:47