Panasonic KX-HNC710W Installation Manual page 18

Setup
2 Siding
3 Structure behind siding
Concrete
R Do not use the included screws.
Use screw anchors (screw
ø4 mm (
for concrete walls.
R Carefully read the instructions
supplied with the anchors.
Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any
debris after drilling the pilot hole.
1
Mark the hole depth on the
drill bit ( 1 ) and then drill a
pilot hole.
2
Remove debris.
3
Insert an anchor, tighten the
screw, then remove the screw
to secure the anchor.
18
HNC710_(en_en)_0207_ver.110.pdf
5
/ inches)) designed
32
1
For assistance, please visit http://shop.panasonic.com/support
18
4
Insert the screw and tighten it.
2
2 Wall mounting adaptor
ALC (autoclaved lightweight
cellular concrete)
R Depending on the type of ALC
panel, you may not be able to
attach the camera. Consult the
ALC panel manufacturer.
R Do not use the included screws.
After consulting the
manufacturer of the ALC panel,
use only commercially-available
metal screw anchors (screw
5
ø4 mm ( / inches)) designed
32
for ALC panels.
R Carefully read the instructions
supplied with the anchors.
Follow instructions regarding
drill bit diameter, hole depth, etc.
R Drill a pilot hole. Remove any
debris after drilling the pilot hole.
R Seal the pilot hole with a
commercially-available
waterproof sealant.
Other materials (mortar, tile,
etc.)
R Do not use the included screws.
R Consult the builder or licensed
professional regarding the type
2018/02/07 20:11:47