Panasonic KX-HNC710W Installation Manual page 22

Appendix
interference that may cause undesired
operation.
Privacy of communications may not be
ensured when using this device.
CAUTION:
Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate this device.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
22
HNC710_(en_en)_0207_ver.110.pdf
For assistance, please visit http://shop.panasonic.com/support
22
– Consult the dealer or an experienced radio/
TV technician for help.
Some devices operate at frequencies that
may cause interference to nearby TVs and
VCRs. To minimize or prevent such
interference, this device should not be placed
near or on top of a TV or VCR. If interference
is experienced, move this device further away
from the TV or VCR. This will often reduce or
eliminate interference.
FCC RF Exposure Warning:
R This product complies with FCC radiation
exposure limits set forth for an uncontrolled
environment.
R To comply with FCC RF exposure
requirements, the device must be installed
and operated 20 cm (8 inches) or more
between the product and all person's body.
R This product may not be collocated or
operated in conjunction with any other
antenna or transmitter.
FCC Warning:
To ensure compliance with FCC emissions
limits, use only the provided USB cable with
ferrite core when connecting the unit to a
computer.
Notice:
R FCC ID can be found inside the interface
cover on the bottom of the unit.
2018/02/07 20:11:47