Charging The Wireless Monitor - Panasonic VL-SDM200A Operating Instructions Manual

R When the Wireless Camera is
Camera is not displayed.

Charging the Wireless Monitor

Charge the Wireless Monitor before using it.
1
Insert the battery pack.
R Open the cover (A), insert the battery pack (B), and then close the battery cover (A).
2
Plug the power plug into the power outlet (120 V AC, 60 Hz) (A).
Charge contacts
(metal parts)
3
Place the Wireless Monitor on the lower part of the Base Unit (B), and then firmly push it into the
Base Unit until it clicks into place (C). Check that the charge indicator lights up.
R While charging: the charge indicator lights up.
When charging is completed: the charge indicator turns off.
(It takes about 6 hours to complete charging.)
R Even after the Wireless Monitor is fully charged, the Wireless Monitor can be left on the Base Unit
without causing it to overcharge.
R When the battery pack is completely out of power, it may take some time until the charge indicator
lights up (about 5 minutes) when charging the Wireless Monitor. This is not a malfunction.
R When removing the Wireless Monitor from the Base Unit, remove the upper part of the Wireless
Monitor first.
Do not unplug the power plug from the power outlet when recharging is completed. (Images
from the Wireless Camera cannot be monitored when the power plug is unplugged from the
power outlet.)
(Out of range), the remaining battery power symbol of the Wireless
A
Battery cover
B
Charge indicator
2
A
Power plug
C
Pin
Getting Started
15