Panasonic KX-HNC710W Installation Manual page 5

using the product to ensure proper and safe
operation of your product.
Power connection
R Use only the 5.0 V, 1.0 A or higher
power source.
R Do not overload power outlets and
extension cords. This can result in
the risk of fire or electric shock.
R Unplug the product from power
outlets if it emits smoke, an
abnormal smell, or makes an
unusual noise. These conditions
can cause fire or electric shock.
Confirm that smoke has stopped
emitting and contact us at http://
shop.panasonic.com/support
R Unplug from power outlets and
never touch the inside of the
product if its casing has been
broken open. Danger of electric
shock exists.
R Never touch the plug with wet
hands. Danger of electric shock
exists.
R Do not connect non-specified
devices.
Installation
R Do not place or use this product
near automatically controlled
devices such as automatic doors
and fire alarms. Radio waves
For assistance, please visit http://shop.panasonic.com/support
HNC710_(en_en)_0207_ver.110.pdf
WARNING
5
Important Information
emitted from this product may
cause such devices to malfunction
resulting in an accident.
R Do not allow the power cord to be
excessively pulled, bent or placed
under heavy objects.
R Do not mount the bracket in a
location higher than 2.2 m (7 feet 3
inches), in an unstable location, in a
location subject to frequent
vibration, on a ceiling, or on a weak
wall. (Do not mount on gypsum
board, concrete blocks, wooden
materials exposed to the outdoors,
walls with very rough surfaces, or
surfaces that are narrower than the
width of the wall mount bracket.)
There is a risk of injury if the
product falls, or of fire or electric
shock if water enters the product.
R Keep small parts (screws, washers,
etc.) out of the reach of children.
There is a risk of swallowing. In the
event they are swallowed, seek
medical advice immediately.
Operating safeguards
R Unplug the product from power
outlets before cleaning. Do not use
liquid or aerosol cleaners.
R Do not disassemble the product.
R Never put metal objects inside the
product. If metal objects enter the
product, turn off the circuit breaker
and contact an authorized service
center.
5
2018/02/07 20:11:47