Selecting A Stitch; Selecting A Font - Husqvarna Viking Tribute 145C User Manual

Table of Contents

19. The icon for lowering the feed teeth is shown when sewing on

buttons is selected.

20. Set the number of stitches to sew on the button by touching the –

and + icons.

21. Recommendation to use the multipurpose tool (optional accessory,

part number 4131056-01) when sewing on a button. Place the thin

end of the multipurpose tool under the button when sewing on light

fabrics. Use the thick end for heavier fabrics.

SELECTING A STITCH

The stitches available are pictured inside the lid of your machine with

the menu numbers on the left and the stitch numbers within the menus

across the center.

Touch the Stitch/Font Menu icon (A) to open the stitch/font selection

window. There are three tabs to choose from – Stitches, My Stitches and

Fonts. The last used tab is active when opening the Stitch/Font menu.

Touch the Stitches tab.

Touch to select any of the four menus. The number of the selected menu

is shown above the stitch menus.

When you have selected a menu, select the stitch you wish to use by touching the corresponding number on the stitch selection

numbers (B). Touch delete (C) if you touch the wrong number. Confirm your selection by touching OK. The stitch selection

menu is closed and the stitch is selected.

If you touch OK without making a stitch selection, the machine beeps indicating that you need to make a selection.

If no selection is made, close the stitch/font selection window again by touching the Stitch/Font menu icon.

If the stitch number entered does not exist in the selected menu you will hear a beep.

The selected stitch menu, stitch and stitch number will be visible on the TouchScreen in Sewing Mode. To select another stitch

in the same menu just touch the Navigator Arrows to move stitch by stitch in numerical order. You can also open the Stitch/

Font menu and make a direct selection by touching the corresponding digits on the screen. To select a stitch in another menu

you will first need to change stitch menu and then select the stitch.

Touch the Stitch/Font Menu icon to open the Stitch/Font selection

window. Touch the Font tab. Touch the font you wish to use, the mode

for programming letters is automatically opened, see page 22.

There are four fonts to choose from; Block, Brush Line, Cyrillic and

Hiragana.

Sewing on button

OPERATING YOUR SEWING MACHINE – 21

Table of Contents