Table of Contents
Advertisement
The Stitch Cannot be Saved
This message is shown if you try to save a buttonhole, bartack,
darning or Automatic Tapering stitches or the sew on button
stitch to My Stitches. All stitches in your machine can be saved
in My Stitches except for these. Close the pop-up message
with OK.
Program too Long to Add More Stitches
If you try to add more than 20 stitches or letters in the same
program this message is shown. Close the pop-up message
with OK.
Note: If you add a FIX, STOP or a Thread Cut to the program these
will each use one memory space in the program.
The Combination of Commands is Incorrect
If you are programming stitches or letters and try to insert
any of the functions STOP, FIX or Thread Cut into a stitch
program in an order that is not allowed, this message will
appear. Close the pop-up message with OK.
Commands Removed from Program
If you try to insert a previously saved program into a new one
or if you are using the mirroring end to end function on the
whole program, the result may be that the commands are put
in an order that is not allowed. To avoid this, the commands
will be removed from the program. Close the pop-up message
with OK.
Bobbin Thread Low
Your machine stops when the bobbin is almost empty. Replace
the empty bobbin with a full one and close the pop-up
message with OK.
Note: Continue sewing without closing the pop-up message if you want all
thread on the bobbin to run out.
Remove Thread from Under Stitch
Plate And In Bobbin Area
When this pop-up message appears clean thread and lint from
the area under the stitch plate to allow the Automatic Thread
Cutter to cut properly. Close the pop-up message with OK.
42 – POP-UP MESSAGES
Advertisement
Table of Contents
