Driver Installation - Dell UltraSharp U2424H User Manual

Driver installation

Install the Realtek USB GBE Ethernet Controller Driver available for your system.
This is available for download at www.dell.com/support. Enter your monitor model
number in the Search bar to identify the product, and then find the software under
Drivers & Downloads section.
Network (RJ45) data rate through USB-C max speed is 2500 Mbps.
Wake-on-LAN behavior
Computer power
save state
Modern Standby
(S0ix)
Standby/Sleep (S3)
Hibernate (S4)
OFF/Shutdown (S5)
NOTE: The computer BIOS must be configured to enable WOL function.
NOTE: This LAN port is 1000Base-T IEEE 802.3az compliant,
supporting Mac Address (Printed on model label) Pass-thru (MAPT),
Wake-on-LAN (WOL) from standby mode (S3 only) and UEFI* PXE
Boot function [UEFI PXE Boot is not supported on Dell Desktop PC's
(except for OptiPlex 7090/3090 Ultra Desktop)], these 3 features
depend on BIOS settings and version of the OS. Functionality may vary
with non-Dell PC's.
*UEFI stands for Unified Extensible Firmware Interface.
NOTE: WOL S4 and WOL S5 only capable with Dell Systems that
support DPBS and is with USB-C connection only.
NOTE: Any issue related to WOL, user should debug the computer
without monitor. After the problem is solved, then connect to the
Monitor.
Computer behavior after receiving Wake-on-LAN
Computer and monitor remain in Standby but network
communication enabled.
Both Computer and monitor turned on.
Both Computer and monitor turned on.
Both Computer and monitor turned on.
(WOL) command
About your monitor
│
35