Sending An Image Via Mail - E-Mail (Smtp) Menu; Common Tab - Setting The E-Mail (Smtp) Function - Sony IPELA SNC-CS10 User Manual

Sending an Image via
mail
— e-Mail (SMTP) Menu
When you click e-Mail (SMTP) on the Administrator
menu, the e-Mail (SMTP) menu appears.
By using e-Mail (SMTP) function, you can send a mail
with attached image file which has been shot linked with
the external sensor input or with the built-in motion
detection function. The image file can also be sent
periodically.
The e-Mail (SMTP) menu is composed of three tabs:
Common, Alarm sending and Periodical sending.
Common Tab — Setting the e-Mail
(SMTP) Function
e-Mail (SMTP)
Select On when you use the e-Mail (SMTP) function.
The common setting options are displayed below.
If you do not wish to use the e-Mail (SMTP) function,
select Off and click OK.
Notes
• During transmission of an image file via mail, the
frame rate and operation performance of the monitor
image of the main viewer decline.
• While the camera Video mode is set to MPEG4, the
image of the composite video signal output from the
video output connector of the camera may be distorted
during mail transmission.
• You cannot send an audio file by using the mail
sending function.
SMTP server name
Type the SMTP server name up to 64 characters, or the
IP address of the SMTP server.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is required when an e-
mail is sent.
On: Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the POP server
name, User name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, make sure to select
either or both SMTP or/and POP before SMTP.
POP server name
It is necessary when the POP before SMTP is selected
in Authentication.
Type the POP (receiving mail) server name up to 64
characters, or type the IP address of the POP server. This
setting is necessary when the SMTP server which sends
e-mails performs authentication using the POP user
account.
User name, Password
Type the user name and Password of the user who has
the mail account. This setting is necessary when the
SMTP server which sends e-mails performs
authentication.
Recipient e-Mail address
Type the recipient e-Mail address up to 64 characters.
You can specify up to three recipient e-Mail addresses.
Administrator e-Mail address
Type the Administrator e-Mail address up to 64
characters.
This address is used for reply mail and sending system
messages from the SMTP server.
Subject
Type the subject/title of the e-Mail up to 64 characters.
When Alarm sending of the alarm tab is set to On, the
mail sent due to the alarm detection will indicate the
type of alarm in the subject. [S1] is added for sensor
input detection, and [MD] is added for motion detection.
Message
Type the text of the e-Mail up to 384 characters. (A line
break is equivalent to 2 characters.)
Sending an Image via mail — e-Mail (SMTP) Menu
43