Setting The Security - Security Menu; Sending An Image Via E-Mail - E-Mail (Smtp) Menu; Common Tab - Setting The E-Mail (Smtp) Function; Security Function - Sony Ipela SNC-CH140 User Manual

Setting the Security
— Security Menu
When you click Security
Security menu appears.
This allows you to control which computers can have
access to the camera.
Likewise, when using IPv6, security settings can be
configured for each network.

Security function

To activate the security function, select On.

Default policy

Select the basic policy of the limit from Allow and Deny
for the computers specified in the Network address/
Subnet 1 to Network address/Subnet 10 menus below.
Network address/Subnet 1 to Network
address/Subnet 10
Type the network addresses and subnet mask values that
you want to allow or deny access to the camera.
You can specify up to 10 network addresses and subnet
mask values. For a subnet mask, type 8 to 32.
(In the case of IPv6, enter a value between 8 and 128.)
Select Allow or Deny from the drop-down list on the
right for each network address/subnet mask.
Tip
The subnet mask value represents the bit number from
the left of the network address.
For example, the subnet mask value for "255.255.255.0"
is 25.
If you set 192.168.0.0/24 and Allow, you can allow
access from computers having an IP address between
"192.168.0.0" and "192.168.0.255."
Note
You can access the camera even from a computer having
an IP address whose access right is set to Deny, if you
enter the user name and password set for the
Administrator boxes in the User menu.
OK/Cancel
See "Buttons common to every menu" on page 26.
58
Setting the Security — Security Menu
in the Administrator menu, the
Sending an Image via
E-mail
— e-Mail (SMTP) Menu
e-Mail (SMTP)
When you click
menu, the e-Mail (SMTP) menu appears.
Using the e-Mail (SMTP) function, you can send an
e-mail with an attached image file that has been shot
linked with an external sensor input or with the built-in
motion detection function. The image file can also be
sent periodically.
The e-Mail (SMTP) menu consists of three tabs:
Common, Alarm sending and Periodical sending.
Common Tab — Setting the e-Mail
(SMTP) Function
e-Mail (SMTP)
Select On when you use the e-Mail (SMTP) function.
Notes
• You cannot send an audio file by using the e-mail
sending function.
• The frame rate and operability on the main viewer
may be reduced while a file is being transmitted by the
e-Mail (SMTP) function.
SMTP server name
Type the SMTP server name using up to 64 characters,
or the IP address of the SMTP server.
SMTP port number
Enter a port number from 25 to 65535.
The standard port number is 25. If TLS is enabled, the
standard port number for SMTPs is 465.
Use TLS
To use the encryption function by TLS, select On.
in the Administrator