Downloading And Starting Software - Siemens SIMATIC RF1000 Configuration Manual

Downloading and starting software

The software for configuring the SIMATIC RF1000/RF1100 readers and the associated
transponders or card types consists of the following components:
• Config editor
• Uploader
Both software components are contained in the "RF1000_ConfigTool_Package.exe" file,
which you can download from the pages of the Siemens Industry Online Support
support.industry.siemens.com/cs/ww/en/ps/24223/dl). This file also contains a sample
configuration for configuring your readers (see also section "Preset configuration cards
(Page 39)").
Downloading and starting the software
Follow these steps to download and start the configuration software:
1. Download the "RF1000_ConfigTool_Package.exe" file to your PC.
2. Run the file and save the extracted files under the desired destination folder.
3. Run the "RF1000_ConfigTool.exe" installation file in the destination folder to install the
software components.
4. Start the application by double-clicking on the file "config_editor.exe" or via the entry in the
start menu.
Result: The configuration software is started.
Note
Functional scope of configuration software
The procedure for creating, adapting and transferring a configuration using the configuration
software is described below. All other functions of the configuration software that are not
described in more detail are not supported by the SIMATIC RF1000/RF1100 readers or should
only be used by trained personnel.
SIMATIC RF1000, RF1100
Configuration Manual, 08/2023, C79000-G8976-C647-03
4
(https://
11