Needle Stop Up/Down (Permanent); Changing The Stitch Plate - Bernina 435 User Manual

Sewing Preparation
> To position the needle position to the right, push the button«Needle Position Right» (2).

Needle Stop Up/Down (Permanent)

> To set the needle stop position permanently, tap «Needle Stop Up/Down».
> Tap «Needle Stop Up/Down» again.

Changing the Stitch Plate

The stitch plate is marked with vertical, horizontal and diagonal lines in millimeters (mm) and inches (inch).
These markings are helpful for sewing or precise top-stitching.
> Lower the feed dog.
> Switch off the machine.
> Remove the needle and presser foot.
> Press the stitch plate down at the marking at the back on the right until it tilts.
> Remove the stitch plate.
> Place the openings of the new stitch plate above the corresponding guide pins and press down until it
36
– The machine stops with needle position down as soon as the foot control is released or the button
«Start/Stop» has been pushed.
– The machine stops with needle position up as soon as the foot control is released or the button
«Start/Stop» has been pushed.
clicks into place.