Planet IGS-4215-4P4Tv2 User Manual page 339

• PD Type
• Extended Mode
• Priority
• PD Class
• Current Used [mA]
• Power Used [W]
• Power Allocation
Buttons
: Click to apply changes.
It allows user to enable legacy mode or force power function in a specified PoE
Inline mode.
Standard: (default)

Fully conforms to the IEEE 802.3 at/bt standard
Legacy:

The legacy detection is to identify the valid current signature of the
PDs that do not fully follow the IEEE 802.3af/at standard. This
protects against damage to the PDs as the right PoE mode is
applied.
Force:

Once the force power is enabled, the PoE port will ignore the PoE
classification behaviors and directly deliver power over UTP cable no
matter what Ethernet device is attached, or even there is no Ethernet
cable plugged.
Please be careful when using force power function and make sure
the remote device is PoE powered device (PD).
For user to enable or disable per port PoE Extension function.
Default setting is "Disable".
In the Extend operation mode, the PoE port operates at 10Mbps duplex operation
but can support PoE power output over a distance of up to 250 meters overcoming
the 100m limit on Ethernet UTP cable.
The Priority represents PoE ports priority. There are three levels of power priority
named Low, High and Critical.
The priority is used in case the total power consumption is over the total power
budget. In this case the port with the lowest priority will be turned off, and offer
power for the port of higher priority.
Displays the class of the PD attached to the port, as established by the
classification process. Class 0 is the default for PDs. The PD is powered based on
PoE Class level if the system is working in Classification mode. The PD will return
to Class 0 to 4 in accordance with the maximum power drawn as specified by
Table 4-15-2-1.
The Power Used shows how much current the PD currently is using.
The Power Used shows how much power the PD currently is using.
It can limit the port PoE supply watts. Per port maximum value must be less than
30.8/36 watts. Total port values must be less than the Power Reservation value.
Once power overload is detected, the port will auto shut down and keep in
detection mode until PD's power consumption is lower than the power limit value.
339
User's Manual of IGS-4215 PoE Series