Planet IGS-4215-4P4Tv2 User Manual page 30

■ Gigabit TP Interface
10/100/1000BASE-T copper, RJ45 twisted-pair: Up to 100 meters.
■ 100/1000BASE-X SFP Slots
Each of the SFP (Small Form-factor Pluggable) slots supports dual-speed, 1000BASE-SX/LX or 100BASE-FX
- For 1000BASE-SX/LX SFP transceiver module: From 550 meters (multi-mode fiber) to 10/20/30/40/50/60/70/120
kilometers (single-mode fiber).
- For 100BASE-FX SFP transceiver module: From 2 kilometers (multi-mode fiber) to 20/40/60 kilometers (single-mode
fiber).
■ Console Port
The console port is an RJ45 port connector. It is an interface for connecting a terminal directly. Through the console port, it
provides rich diagnostic information including IP address setting, factory reset, port management, link status and system
setting.
Users can use the attached DB9 to RJ45 console cable in the package and connect to the console port on the device.
After the connection, users can run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the startup screen of the device.
■ Reset Button
On the left of the front panel, the reset button is designed to reboot the Industrial Managed Switch without turning off and
on the power. The following is the summary table of reset button functions:
Reset Button
Press the reset button for < 5 seconds
for system reboot.
Press the reset button for > 5 seconds
for factory default.
Reset button
Function
Reboot the Industrial Managed Switch.
Reset the Industrial Managed Switch to Factory Default
configuration. The Industrial Managed Switch will then reboot
and load the default settings shown below:
Default username: admin
。
Default password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default gateway: 192.168.0.254
。
30
User's Manual of IGS-4215 PoE Series