Installation; Maintenance - BEA IXIO-DT1 Quick Start Manual

READ BEFORE BEGINNING INSTALLATION/PROGRAMMING/SETUP

INSTALLATION

The sensor should
be mounted securely
to avoid extreme
vibrations.

MAINTENANCE

SAFETY
The door control unit
and the header cover
profile must be correctly
grounded.
BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
BEA, Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or incorrect adjustments of the sensor/device;
therefore, BEA, Inc. does not guarantee any use of the sensor/device outside of its intended purpose.
BEA, Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/
gates, and factory-trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring
that the sensor/device system performance is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer's
recommendations and/or per AAADM/ANSI/DASMA guidelines (where applicable) for best industry practices. Safety inspections must
be performed during each service call – examples of these safety inspections can be found on an AAADM safety information label (e.g.
ANSI/DASMA 102, ANSI/DASMA 107, UL294, UL325, and International Building Code).
Verify that all appropriate industry signage, warning labels, and placards are in place.
Page 2 of 12
Do not cover the sensor.
It is recommended to clean
the optical parts at least once
a year or more if required due
to environmental conditions.
Only trained and
qualified personnel
are recommended for
installation and setup of
the sensor.
Avoid moving objects
and light sources in the
detection field.
Following installation,
always test for proper
operation (according
to ANSI 156.10) before
leaving the premises.
Avoid highly reflective
objects in the infrared
field.
Do not use aggressive
products to clean
the optical parts.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
75.5751.12 IXIO-DT1 20230913