Table of Contents
Advertisement
LED-SIGNAL
Motion
detection
LED flashes
x
INSTALLATION
The sensor should be
fixed firmly to avoid
extreme vibrations.
MAINTENANCE
SAFETY
The door control unit and
the door cover profile
must be correctly earthed.
•
The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the
manufacturer of the sensor.
•
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the sensor and
the door system in compliance with applicable national and international regulations and standards on door safety.
•
The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate adjustments of
the sensor.
Presence
detection
LED flashes x
times
Do not cover the sensor.
It is recommended to clean
the optical parts at least once a
year or more if required due to
environmental conditions.
Only trained and
qualified personnel may
install and setup the
sensor.
LED flashes
red-green
Avoid moving objects
and light sources in the
detection field.
Always test the good
functioning of the
installation before
leaving the premises.
LED flashes
LED is off
quickly
Avoid highly reflective
objects in the infrared
field.
Do not use aggressive
products to clean
the optical parts.
The warranty is invalid if
unauthorized repairs are made
or attempted by unauthorized
personnel.
7
Advertisement
Table of Contents
