Led Signals; Troubleshooting - BEA IXIO-DT1 Quick Start Manual

LED SIGNALS

COLORS
(green)
Motion detection
(red)
Presence detection

TROUBLESHOOTING

E1: ORANGE LED
flashes 1x
1
E2: ORANGE LED
flashes 2x
2
E4: ORANGE LED
4
flashes 4x
E5: ORANGE LED
5 flashes 5x
E8: ORANGE LED
8 flashes 8x
ORANGE LED is on
RED LED flashes quickly
after an assisted setup
RED LED illuminates
sporadically
75.5751.12 IXIO-DT1 20230913
BEHAVIORS
The sensor signals an internal
fault.
The power supply voltage is
too low/high.
The sensor does not receive
enough AIR energy.
The sensor receives too much
AIR energy.
The sensor is disturbed by
external elements.
AIR power emitter is faulty.
The sensor encounters a
memory problem.
The sensor sees the door
during assisted setup.
The sensor vibrates.
The sensor sees the door.
The sensor is disturbed by
external conditions.
LED flashes
LED flashes quickly
LED flashes x times
x
Replace sensor.
Check power supply voltage in diagnotistics
menu (menu 3) of the LCD.
Check wiring.
Decrease the angle of the AIR curtains.
Increase the AIR immunity filter.
Deactivate curtain #2 (C2, outer curtain).
Slightly increase the angle of the AIR curtains.
Decrease the AIR immunity filter.
Eliminate the cause of disturbance (lamps,
rain cover, door controller housing properly
grounded).
Replace sensor.
Cut and restore power supply.
If ORANGE LED illuminates again, replace the
sensor.
Move the AIR curtains away from the door.
Install the sensor as close to the door as
possible. If needed, use a bracket assembly.
Ensure that the bottom of the sensor is mounted
within 2" of the bottom of the door header.
Launch a new assisted setup.
Check if the sensor is secure.
Check position of cable and cover.
Adjust the AIR angle and launch an assisted
setup.
Increase the AIR immunity filter.
LED flashes red-green
LED is off
Page 11 of 12