Table of Contents
Advertisement
LED-SIGNAL
Motion
detection
LED flashes
INSTALLATION
Avoid extreme
vibrations.
MAINTENANCE
It is recommended to clean
the optical parts at least once
a year or more if required due
to environmental conditions.
SAFETY
The door control unit
and the door cover
profile must be correctly
grounded.
•
The device should not be used for purposes other than its intended use. All other uses cannot be
guaranteed by the manufacturer of the sensor.
•
The installer of the door system is responsible for carrying out a risk assessment and installing the sensor and
the door system in compliance with applicable national and international regulations and standards on door
safety.
•
The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate
adjustments of the sensor.
•
The Sensor should be properly installed and adjusted and the proper functioning of the Sensor, when
installed with an end product, as intended in UL 325 standard, shall be verified by the installer.
75.5785.01 IXIO-ST UL INDUSTRIAL 20140402
Presence
detection
LED flashes
x times
x
Do not cover the sensor.
Only trained and
qualified personnel
may install and setup
the sensor.
LED flashes
LED flashes
quickly
red-green
Avoid moving objects
and light sources in
the detection field.
Do not use aggressive
products to clean
the optical parts.
Always test the proper
operation of the
installation before
leaving the premises.
LED is off
Avoid highly
reflective objects in
the infrared field.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
Page 7 of 8
Advertisement
Table of Contents
