HP 6200 Pro Microtower Series Hardware Reference Manual page 35

6. Open both latches of the memory module socket (1), and insert the memory module into the
socket (2).
Figure 2-7
NOTE:
with the tab on the memory socket.
Populate the black DIMM sockets before the white DIMM sockets.
For maximum performance, populate the sockets so that the memory capacity is spread as
equally as possible between Channel A and Channel B. Refer to
on page 25
7. Push the module down into the socket, ensuring that the module is fully inserted and properly
seated. Make sure the latches are in the closed position (3).
8. Repeat steps 6 and 7 to install any additional modules.
9. Replace the computer access panel.
10. Reconnect the power cord and turn on the computer.
11. Lock any security devices that were disengaged when the access panel was removed.
The computer should automatically recognize the additional memory the next time you turn on the
computer.
ENWW
Installing a DIMM
A memory module can be installed in only one way. Match the notch on the module
for more information.
Populating DIMM Sockets
Installing Additional Memory 27