Installing Additional Memory; Dimms; Ddr3-Sdram Dimms - HP 6200 Pro Microtower Series Hardware Reference Manual

Table 2-1 System Board Connections (continued)
No. System Board Connector
17 USB
18 SATA 2.0
19 SATA 3.0
20 SATA 3.0
21 SATA 2.0
22 eSATA
23 Serial Port

Installing Additional Memory

The computer comes with double data rate 3 synchronous dynamic random access memory (DDR3-
SDRAM) dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs.
These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum
memory support, you can populate the system board with up to 16-GB of memory configured in a
high-performing dual channel mode.

DDR3-SDRAM DIMMs

CAUTION:
processor is not compatible with DDR3U memory and if you plug DDR3U memory into the system
board, it can cause the physical damage to the DIMM or invoke system malfunction.
For proper system operation, the DDR3-SDRAM DIMMs must be:
●
industry-standard 240-pin
●
unbuffered non-ECC PC3-8500 DDR3-1066 MHz-compliant or PC3-10600 DDR3-1333 MHz-
compliant
●
1.5 volt DDR3-SDRAM DIMMs
The DDR3-SDRAM DIMMs must also:
●
support CAS latency 7 DDR3 1066 MHz (7-7-7 timing) and CAS latency 9 DDR3 1333 MHz
(9-9-9 timing)
●
contain the mandatory JEDEC SPD information
24 Chapter 2 Convertible Minitower (CMT) Hardware Upgrades
System Board Label
MEDIA2
SATA2
SATA0
SATA1
SATA3
ESATA
COMB
This product DOES NOT support DDR3 Ultra Low Voltage (DDR3U) memory. The
Color Component
black USB Device, such as a Media Card
Reader
white 3rd Hard Drive, or 1st Optical Drive if
no 3rd Hard Drive
dark blue 1st Hard Drive
light blue 2nd Hard Drive
white 2nd Optical Drive, or 1st Optical
Drive if a 3rd Hard Drive exists
black eSATA Adapter Cable, or 2nd
Optical Drive if a 3rd Hard Drive
exists
black Serial Port
ENWW