End Position Of Lower Looper - Setting Of; The Lower Looper In Relation To The Needle - Husqvarna VIKING HUSKYLOCK 936 Service Manual

4. END POSITION OF LOWER LOOPER - SETTING OF

THE LOWER LOOPER IN RELATION TO THE NEEDLE

CHECK
When lower looper is positioned at it's left end turning position, the clearance
between its point and left side of left needle should be 3.0 ± 0.2 mm.
ADJUSTMENT
1. Move lower looper to its left end position by turning the handwheel towards you.
2. Loosen screws of the lever (A) of the lower looper. Adjust distance between left side
of the needle and the piont of the lower looper to 3.0 ± 0.2 mm.
3. Tighten screws.
B = Lower looper
104 72 49-26 Husqvarna Viking Huskylock 936 9