Clearance Between Needles Support And Needle - Needles (A),(B) And (E) - Husqvarna VIKING HUSKYLOCK 936 Service Manual

13. CLEARANCE BETWEEN NEEDLES SUPPORT AND NEEDLE
- NEEDLES (A),(B) AND (E)
CHECK
When needle is in its lower turning position the needle shall not at any point touch
the rear needle support (F) .
Valid for Schmetz #90.
ADJUSTMENT
1. Loosen screw (H) of the needle support
2. Adjust the needle support until the clearance
to the needle is G = 0.05-0.1 mm
3. Tighten screw (H).
F = Needle support
J = Frame
Note! On Ver 2 the Needle support is located on the Chain stitch looper
18 Husqvarna Viking Huskylock 936 104 72 49-26