GENERAL DISMOUNTING
To carry out all the recommended settings in this service manual the following parts
should be dismounted first.
1. Remove support bed (1) and free arm (2).
2. Dismount upper side cover (3) by removing the screw (A) .
3. Dismount lower side cover (4) by removing the three screws (B) .
4. Remove screws (D, E,F,G,H and I) then open front cover, and remove the base plate (5)
towards left side.
5. Remove presser foot lifter (9).
6. Remove the two screws (C) and dismount the motor cover (6).
7. Dismount the rear cover (7) by removing screw (J).
8. Remove thread take up (K).
9. Remove screws (M,N) and dismount the front cover.
NOTE ! Set the needle in its lowest position.
10. Remove the cable from the circuit board on the front cover.
11. Mounting in reverse order.
K
N
104 72 49-26
Husqvarna Viking Huskylock 936
5