11. CLEARENCE BETWEEN DOUBLE CHAIN
LOOPER AND NEEDLE
Check
When point of the double chain looper is behind the needle, the clearance between needle
and double chain looper should be 0 - 0.3 mm.
Adjustment
1. Set point of the double chain looper behind the centre line of the needle by turning the
handwheel towards you.
2. Loosen screw (A) on the double chain looper and adjust clearance between needle and
point of looper by moving the double chain looper until it is 0 - 0.3 mm.
3. Tighten the screw (A).
16 Husqvarna Viking Huskylock 936
104 72 49-26