Cable Termination For Rgb Video And Audio Transmission - Extron electronics PVT CV User Manual

e
RGB video input (RGB C�, RGB, and SW RGB models) —
Connect a computer video source to this 15-pin HD
connector for high resolution RGB video input.
ä
cable A output
RGB
Using TP cable, connect this RJ-45 female output port,
labeled "RGB A out", to one of the two input ports
(labeled 1A and 2A) on the PVS 204SA switcher.
ã
cable B output
RGB
Using TP cable, connect this RJ-45 female output port,
labeled "RGB B out", to one of the two input ports
(labeled 1B and 2B) on the PVS 204SA switcher.

Cable termination for RGB video and audio transmission

N
N
N
N
568A
Cable A
Pin Wire Color
1 White-green
Red +
2 Green
Red –
3 White-orange
H. sync +
4 Blue
Green +
5 White-blue
Green –
6 Orange H. sync –
7 White-brown
Blue +
8 Brown
Blue –
Figure 2-10 — Wiring twisted pair cables A and B
PVT Series (Rack Mount Models) • Installation
Get other manuals https://www.bkmanuals.com
(RGB C�, RGB, and SW RGB models)
(RGB C�, RGB, and SW RGB models)
The PVT cable termination method is specific for PVT
transmitters working with the PVS 204SA switcher.
DO NOT connect these devices to an MTP system.
RJ-45 termination with CAT 5, CAT 5e, CAT 6, and
Skew-Free A/V UTP cable must comply with the
TIA/EIA T 568A wiring standards for all connections.
For RGB signals, the RJ-45 connectors must be wired
exactly as shown in the figure 2-10, using the same
wiring table for both ends, so that the correct input
signal (video on cable A and audio on cable B) is carried.
Cable B carries the audio signal, the vertical sync
information, and 5 VDC to power the PVT transmitters.
TP Cable and
CAT 5 Connector
Cable B
V. sync +
V. sync –
+ 5 VDC
Audio L +
Audio L –
GND
Audio R +
Audio R –
Clip Down
Side
Pins 1 2 3 4 5 6 7 8
RJ-45
Connector
1 2 3 4 5 6 7 8
Twisted
1&2
3&6 4&5 7&8
—
—
Pairs
2-11