Table of Contents
Advertisement
im Vertrieb von
Installation, cont'd
PVT RGB models
2a
A
RGB OUT
PVT RGB D
Figure 2-10 — PVT RGB models rear panel features
Ç
RGB
female output port labelled "RGB A out" to one of the two
input ports (labelled 1A and 2A) on the PVS 204SA switcher.
É
RGB
female output port labelled "RGB A out" to one of the two
input ports (labelled 1B and 2B) on the PVS 204SA switcher.
Cable termination for PVT RGB models
N
N
N
N
www.camboard.de
PVT Series (D and AAP models) • Installation
2-10
CAMBOARD Electronics
2b
B
6a
2b
6a
2a
PVT RGB AAP
A output — Using CAT 5 UTP cable, connect this RJ-45
B output — Using CAT 5 UTP cable, connect this RJ-45
The PVT cable termination method is specific for
PVT transmitters working with the PVS 204SA
switcher. DO NOT connect to an MTP system.
RJ-45 termination with CAT 5, CAT 5e, CAT 6, and
Skew-Free A/V UTP cable must comply with the
TIA/EIA T 568A wiring standards for all connections.
The cables must be wired exactly as shown in
figure 2-11, so that the output signals (video on cable A,
vertical sync and audio on cable B) are transmitted
correctly.
Cable B primarily carries the audio signal, the
vertical sync information, and 5 VDC to power
the PVT transmitter
Tel. 07131 911201
Fax 07131 911203
.
ce-info@camboard.de
Advertisement
Table of Contents
