Tp Cable Termination And Recommendations - Extron electronics DTP T FB 332 User Manual

VGA connector wiring
The 15-pin HD (VGA) universal analog input port accepts RGB (RGBHV, RGBS, RGsB) and
component video. Figure 16 shows the pinout for each format type on the connector.
Pin RGBHV
5 1
1 Red
2 Green
15 3 Blue
11
4, 5 NC
6 Red return
7 Green return
8 Blue return
Figure 16.

TP cable termination and recommendations

Figure 17 details the TIA/EIA T 568 B wiring standard. Use this standard to terminate the
DTP cable with RJ-45 connectors.
Side
Pair Wires
Figure 17.
NOTE: Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201
cable to link the switching transmitter and receiver. The DTP T FB units do not work
properly with these cables.
Supported cables
The DTP T FB units are compatible with shielded twisted pair (STP) and unshielded twisted
pair (U/UTP) cable. However, Extron strongly recommends that you use STP cable to
achieve best performance.
ATTENTION:
• To ensure FCC Class A and CE compliance, STP cables and STP connectors are
required.
• Afin de s'assurer de la compatibilité entre FCC Classe A et CE, les câbles STP et
les connecteurs STP sont nécessaires.
RGBS Component
Red R-Y
Green
Blue B-Y
NC NC
Red return R-Y return
Green return Y return
Blue return B-Y return
VGA Connector
Pins:
RJ-45
1 2 3 4 5 6 7 8
Connector
TIA/EIA T
568 B
Pin Wire color
1 White-orange
2 Orange
3 White-green
4 Blue
5 White-blue
6 Green
Insert
7 White-brown
Twisted
8 Brown
TP Cable Termination
DTP T FB 332 and DTP T FB 232 Twisted Pair Transmitters • Installation
Pin RGBHV
9 NC
Y 10 Ground
11 NC
12
NC
13 H sync
14 V sync
15 NC
RGBS Component
NC NC
Ground NC
NC NC
NC
NC
C sync NC
NC NC
NC NC
13