Connection Details; Hdmi Connection; Twisted Pair Cable Termination And Recommendations For Xtp Communication - Extron electronics XTP T HWP 101 4K User Manual

Connection Details

HDMI Connection

To secure the HDMI cable to the HDMI connector, use an Extron LockIt Cable Lacing
Bracket and a tie wrap.
1
Figure 9.
1.
2.
3.
4.
5.
Twisted Pair Cable Termination and Recommendations for XTP
Communication
Use the following pin configurations for twisted pair cables used for XTP communication.
12345678
Insert Twisted
Pair Wires
Connector
Figure 10.
3
2
Installing the LockIt Lacing Bracket
Plug the HDMI cable into the panel connection (see figure 9,
Loosen the HDMI connection mounting screw from the panel (
LockIt over it. The screw does not have to be removed.
Place the LockIt on the screw and against the HDMI connector (
the screw to secure the bracket.
Loosely place the included tie wrap around the HDMI connector and the LockIt (
While holding the connector securely against the cable lacing bracket, use pliers or
similar tools to tighten the tie wrap. Remove any excess length (
ATTENTION:
• Connect and pull the tie wraps until they are secure. Do not overtighten.
•
Connectez et tirez les serre-câbles jusqu'à ce qu'ils soient sécurisés. Ne pas
trop serrer.
Pins:
TIA/EIA-T568B
T568A
Pin Wire Color
Pin Wire color
1 White-green
1 White-orange
2 Green
2 Orange
3 White-orange
3 White-green
4 Blue
4 Blue
5 White-blue
6 Orange
5 White-blue
7 White-brown
6 Green
8 Brown
7 White-brown
RJ-45
8 Brown
Twisted Pair Cable Termination
4
3
5
T568B
Wire color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
XTP T HWP 101 4K Wallplate Transmitter • Installation
).
1
) enough to place the
2
), and then tighten
3
).
4
).
5
11