Notes On Handling Ink Packs And Ink Tanks; Notes On Handling Paper - Epson SureColor SC-F6300 Series User Manual

SC-F6300 Series User's Guide
❏ If you do not print for a long time, the print head
nozzles may become clogged. Turn the printer on at
least once every two weeks to prevent the print head
clogging.
When the printer is turned on, head cleaning is
performed automatically. Do not turn the printer
off until cleaning is complete.
Leaving the printer for too long without turning it
on may result in a malfunction. If repairs are
necessary, they will be done for a fee.
❏ A service engineer must do pre- and
post-maintenance when the printer is not used for
over 2 weeks. Pre- and post-maintenance will be
provided for a fee.
Moreover, depending on the environment and
length of time stored, repairs may be required
during post-maintenance even if pre-maintenance
is done. If repairs are necessary, they will be done for
a fee.
Contact your dealer or Epson Support.
❏ The roller may leave an impression on paper that is
left in the printer. This can also cause wavy or curled
paper resulting in paper feeding problems or the
print head could be scratched. Remove any paper
when storing.
❏ Store the printer after confirming that the print
head has been capped (the print head is positioned
at the far right). If the print head is left uncapped for
a long time, the print quality may decline.
Note:
If the print head is not capped, turn the printer on, and
then turn it off.
❏ To prevent the accumulation of dust and other
foreign matter in the printer, close all covers before
placing it in storage.
If you are not using the printer for a long time, put
an anti-static cloth or cover on the printer.
The print head nozzles are very small, and they can
become clogged easily if fine dust gets on the print
head, and you may not be able to print properly.
❏ When turned on after an extended period of disuse,
the printer may automatically perform head
cleaning to ensure print quality.
Head cleaning will end after about 10 to 15 minutes.
Introduction
Notes on handling ink packs and
ink tanks
Note the following points when handling ink packs and
ink tanks.
❏ Do not remove the ink tanks.
Removing them may impair quality and
performance.
❏ Store ink packs at room temperature in a location
that is not exposed to direct sunlight.
❏ To ensure print quality, use all the ink in the tank
before the earlier of the following dates:
❏ Expiry date noted on the ink pack
❏ 25 days after the ink tank was refilled
❏ Ink packs that have been stored at low temperatures
for an extended period should be allowed to return
to room temperature over a period of four hours
before use.
❏ When refilling the ink tank with ink, get all the ink
out of the ink pack so that there is none remaining.
❏ Immediately refill the ink tank once the ink pack is
open.
❏ Do not place items on the ink tank or subject the ink
tank to strong impacts. The ink tank could become
detached.
If the ink tank has come off, contact your dealer or
Epson Support.
❏ Do not use if the High Density Black and Black inks
are mixed. When changing the type of Black ink
being used, the ink tank should only be changed by a
service engineer. Changing the Black ink is done for
a fee.
Contact your dealer or Epson Support.

Notes on handling paper

Note the following points when handling and storing
the paper. If the paper is not in good condition, print
quality may decline.
Check the documentation supplied with each paper.
16