Epson SureColor SC-F6300 Series User Manual page 74

SC-F6300 Series User's Guide
Caution:
❏ Store ink packs and waste ink in a location out
of reach of children.
❏ Wear protective eyewear, gloves, and a mask
when performing maintenance.
Should ink or waste ink contact your skin or
enter your eyes or mouth, take the following
actions:
❏ If fluid adheres to your skin, wash it off
using large volumes of soapy water. If you
notice any reaction developing in the
affected area, consult with a qualified
physician immediately.
❏ If ink gets into your eyes, wash them out
immediately with water. Failure to observe
this precaution could result in bloodshot
eyes or mild inflammation. Consult with a
qualified physician if any other problems
should develop.
❏ If fluid enters your mouth, consult with a
physician as soon as possible.
❏ If swallowed, do not induce vomiting.
Consult with a physician as soon as
possible. If vomiting is induced, vomited
material may enter the windpipe, which is
dangerous.
❏ Be aware of the following points when refilling
ink.
❏ Carefully cut open the nozzle on the ink
pack.
If too much force is applied, the ink may
splatter out.
❏ Do not grip the ink pack too strongly after
opening. This may cause the ink to be
squeezed out of the pack.
❏ When pouring the ink into the ink tank,
slowly tilt the ink pack to pour.
Maintenance
c
Important:
❏ Epson recommends the use of genuine Epson
ink packs.
Epson cannot guarantee the quality or
reliability of nongenuine ink. The use of
non-genuine ink may cause damage that is not
covered by Epson's warranties, and under
certain circumstances, may cause erratic
printer behavior.
Information about non-genuine chip unit
status may not be displayed, and use of
non-genuine ink is recorded for possible use in
service support.
❏ Genuine Epson ink, other than those specified
here, could cause damage that is not covered by
Epson's warranties.
"Options and Consumable Products" on
U
page 99
❏ Do not place items on the ink tank or subject the
ink tank to strong impacts. The ink tank could
be detached.
Contact your dealer or Epson Support.
❏ Do not use if the High Density Black and Black
inks are mixed. When changing the type of
Black ink being used, the ink tank should only
be changed by a service engineer. Changing the
type of Black ink is provided for a fee. Contact
your dealer or Epson Support.
A
When Check Ink Levels is displayed on the
control panel screen, check the ink level in the ink
tank.
Make sure the ink level is below the top edge of
the metal plate.
Proceed to step 7 if the status of the chip unit on
the control panel is reserved. Proceed to step 2 if
it is not reserved.
74