Moving To Another Time Zone - Casio 5639 Operation Manual

5.
Rotate the crown to align the hour hand,
minute hand, and 24-hour hand with 12
o'clock.
6.
Press (B).
This enables adjustment of small hour
hand, small minute hand, and small 24-
hour hand alignment.
Small hour hand
Small minute hand
Small 24-hour hand
7.
Rotate the crown to align the small hour
hand, small minute hand, and small 24-
hour hand with 12 o'clock.
8.
Press (B).
This enables function hand and day
indicator alignment.
Function hand
9.
If the function hand and/or the day
indicator is out of alignment, rotate the
crown to adjust them. Move the function
hand to 12 o'clock and/or the day to the
center of the indicator window.
The movement ranges of the function
●
hand and day indicator are limited when
you rotate the crown. The maximum
left-right movement of the function hand
is 180 degrees in either direction. The
day indicator moves only slightly.
After the function hand and day
●
indicator are in the positions you want,
advance to step 12 of this procedure. If
you are unable to make the adjustments
you want, go to step 10.
Operation Guide 5639
10.
Press (B).
Confirm that the day indicator shows "1".
The function hand will move repeatedly
●
while the day setting is being changed.
The function hand may continue to
move for about 20 minutes.
Hand and Day Indicator Movement
l
11.
If "1" is not shown for the day, rotate the
crown until "1" is shown for the day.
Rotating the crown also causes the
●
function hand to move. Move the
function hand to 12 o'clock.
12.
Push the crown back in.
Note
Leaving the crown pulled out for more
●
than approximately 30 minutes without
performing any operation will
automatically cause the adjustment
operation to become disabled. If this
happens, push the crown back in to its
normal position and then pull it out
again to restart the procedure from the
beginning. Pushing the crown in to its
normal position part way through the
alignment procedure will cause the
hands to return to their normal position.
Any alignment you performed up to
that point will be applied.
Day indicator
Moving to Another Time
Zone
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
Before Boarding
●
1.
Configure the World Time (Dual Time)
setting to the current time at your
destination.
Current time
Destination time
Selecting a World Time City
l
2.
Disable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
After Arriving
●
1.
Swap the origin time zone time with the
destination time zone time.
Before swapping After swapping
Destination time
Destination time
Swapping Your World Time and Home
l
Time
2.
Enable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
3.
Adjust the time setting.
Triggering Immediate Time Adjustment
l
15