Adjusting Hand And Day Indicator Alignment; Phone Finder - Casio 5639 Operation Manual

Configuring the Summer Time Setting
●
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Perform the operation shown on the
phone screen to select a summer time
setting.
"Auto"
●
The watch switches between standard
time and summer time automatically.
"OFF"
●
The watch always indicates standard
time.
"ON"
●
The watch always indicates summer
time.
Note
While the summer time setting is
●
"Auto", the watch will switch between
standard time and summer time
automatically. You do not need to
switch between standard time and
summer time manually. Even if you are
in an area that does not observe
summer time, you can leave the
watch's summer time setting as "Auto".
Changing the time setting manually
●
with a watch operation will cancel auto
standard time/summer time switching.
EDIFICE Connected screen shows
●
information about summer time
periods.
Swapping Your World Time and Home
●
Time
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
Operation Guide 5639
3. Y
Perform the operation shown on the
phone screen to swap your Home Time
with your World Time.
For example, if your Home City is Tokyo
and the World Time City is New York, they
will be swapped as shown below.
Before swapping
Home City (Tokyo)
World Time City
(New York)
World Time City
(Tokyo)
Note
Auto time adjustment does not work for
●
24 hours after swapping of the Home
Time and World Time.
Adjusting Hand and Day
Indicator Alignment
If the hands and/or day indicator are out of
alignment even though auto time adjustment
is being performed, use EDIFICE Connected
to adjust them.
1. Y
Tap the "EDIFICE Connected" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
This establishes a connection between
the watch and phone.
3. Y
Perform the operation shown on the
phone screen to correct hand and day
indicator alignment.

Phone Finder

You can use phone finder to trigger a tone on
the phone to make it easy to find. The tone is
forced to sound even if the phone is in vibrate
mode.
After swapping
Home City (New York)
1. X
2. X
3. X
Important!
Do not use this function in areas where
●
phone call tones are restricted.
The tone sounds at a high volume. Do
●
not use this function when listening to
phone output over earphones.
If the watch is connected with a phone,
press any button to terminate the
connection.
This will cause the watch to enter the
Calendar Mode.
Connected Disconnected
Hold down (B) for at least four seconds
until the second hand points to
A connection will be established between
the watch and phone, and then the
phone's ringtone will sound.
It will take a few seconds before the
●
phone tone sounds.
Press any button to stop the tone.
You can press any watch button to stop
●
the phone tone, but only during the first
30 seconds after it starts to sound.
.
e
9