Moving To Another Time Zone; Stopwatch; Measuring Elapsed Time - Casio 3541 Operation Manual

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Use (D) to scroll through the alarm ([1] to
[4], [SNZ]) and hourly time signal ([SIG])
screens until the one you want to turn off
is displayed.
Alarm or hourly time signal
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off an alarm causes
●
(alarm) to disappear from the display.
Turning off the hourly time signal
causes (hourly time signal) to
disappear.
Note
If (alarm) is still displayed
●
after you turn off an alarm, it means that
at least one of the other alarms is still
turned on. To turn off all of the alarms,
repeat steps 2 and 3 until the
(alarm) indicator is no
longer displayed.
Watch Operation Guide 3541
Moving to Another
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
Before Boarding
●
1.
Configure the World Time to the current
time at your destination.
Using CASIO WATCHES to Configure
l
Settings
Using Watch Operations to Configure
l
Settings
2.
Disable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
After Arriving
●
1.
Swap the origin time zone time with the
destination time zone time.
Before swapping
World Time
Destination
Using CASIO WATCHES to Configure
l
Settings
Using Watch Operations to Configure
l
Settings
2.
Enable auto time adjustment.
Using the Watch in a Medical Facility or
l
Aircraft
3.
Adjust the time setting.
Triggering Immediate Time Adjustment
l
Time Zone
Current time
Destination time
After swapping
World Time
Origin

Stopwatch

The stopwatch measures elapsed time in
1/100-second units for the first hour, and in 1-
second units after that for up to 23 hours 59
minutes 59 seconds (24 hours).

Measuring Elapsed Time

1.
Enter the Stopwatch Mode.
Navigating Between Modes
l
2.
Use the operations below to measure
elapsed time.
Start
Stop
Resume
Stop
Elapsed time is shown in 1/100-second
●
units for the first hour of the
measurement. After the first hour,
elapsed time is shown in one-second
units.
First hour After first hour
Minutes, seconds, Hour, minute, second
1/100 seconds
3.
Press (A) to reset the measurement time
to all zeros.
22