4.1.4 User Programming Mode - Panasonic KX-TD816AL Installation Manual

4.1.4 User Programming Mode

Entering the user programming mode
4-12 System Programming
Some programming items are permitted to any display digital
proprietary telephone user in the system.
The programming items are listed below:
[000] Date and Time Set
[001] System Speed Dialing Number Set
[002] System Speed Dialing Name Set
[003] Extension Number Set
[004] Extension Name Set
You can access these programs by entering the User Programming
Mode as follows:
Before entering the mode, confirm that:
• Your telephone is on-hook.
• No calls are on hold at your telephone
Press PROGRAM +
(default: 1234)
After entering the mode, perform the same programming steps as
the system programming steps in each program address.
Notes • If nothing is entered in five seconds after the PROGRAM button is
pressed, it is cancelled.
• The User Password is not shown on the display. The password can be
changed by system programming. Refer to Section 4.3 [120] "User
Password."
• During the programming mode, your extension is treated as a busy
extension.
• Only one digital proprietary telephone can be in programming mode at
any one time.
+ and enter the User Password