8. The Pages
8.1 Line Input (2 Pro and 2/4 Pro SE)
8.1.1 General
Conversion Type
PCM or DSD. Default: PCM. DSD
will not become active at sample
rates below 176.4 kHz. The DSD
rate changes with the chosen
sample rate (Device – Clock Set-
tings – Sample Rate).
Ref. Auto
ON or OFF. Default: OFF. In case of overload Auto Ref Level will switch the Ref Level to the next
higher setting. This process is repeated until +24 dBu is reached. In case Trim Gain was active it
will be set to 0 dB first. Not available in RIAA mode.
Ref Level
Sets the reference level for the analog inputs 1/2. Choices are +1 dBu, +7 dBu, +13 dBu, +19
dBu, +24 dBu, referenced to digital full scale level (0 dBFS).
8.1.2 Parametric EQ
On or Off. Default Off. See also
chapter 8.2.2 for further details on
PEQ settings.
Preset
Load or store up to 22 different EQ Presets. The first choice, Manual, holds the current, unsaved
EQ settings. The second choice, Temp, holds the settings of a loaded and then modified Preset.
This scheme lets the user easily change and compare three different EQ settings: the manual
one, the stored preset and the modified preset, without losing changes while listening to a different
set of EQ settings.
Preset 21, Clear, corresponds to the factory default with all bands at 0 dB. It is not available to
store a preset, but is used for resetting one by overwriting. A preset reset in this way, resulting in
an 'empty' preset, is marked with (lin).
The ADI-2/4 Pro SE has Rumble as Preset 22, a rumble filter for turntable usage.
The EQ Presets are independent from and not stored with Setups on the device. Using the app
Setup files do include all 20 PEQ Presets. On load the current EQ setting is written into the
memory slot Manual.
User's Guide ADI-2 Remote – v 1.0
9