Table of Contents
Advertisement
8.4.5 Display
Lock UI
OFF, Remote, Keys, Keys+Remote. Locks the keys on the device (Keys), the remote control
(Remote) or both (Keys+Remote). Only VOLUME remains operable. To unlock, press and hold
encoder 1.
Mode
Available settings are: Default,
Dark. The dark scheme inverts
the white background and black
numbers/text on the display to
black background and light-grey
numbers/text.
Meter Color
Green, Cyan, Amber, Monochrome, Orange, Red. Default: Cyan. Color of the level meters for
PCM and DSD mode.
Horizontal Meter
The horizontal stereo level meter below the Analyzer can show the peak level before all DSP
processing (Pre, equals the current input level from USB playback and SPDIF In), after all pro-
cessing including volume control (Post), or both at the same time (Dual, default). The outer thin
line is the Pre level. In Dual mode the peak values to the right refer to Post level. Post FX dBu
shows numerical values referenced to dBu.
AutoDark
OFF, ON. Automatically turns off all LEDs and the display (exception: Standby button) after 10
seconds of user inactivity. A key press and turning an encoder will temporarily activate LEDs and
display again. Info and warning messages are shown for 3 seconds.
Volume Screen
ON, OFF. Default: ON. When turning the VOLUME knob at the device the Volume screen is
shown.
8.4.6 Setups
This section allows to save the whole state of the unit as Setup in 9 memory slots. The EQ Presets
are not included, but stored separately. The current state of the EQ is stored, and written to the
EQ memory slot Manual during load of a Setup.
It should be noted that Setup files (!) can have individual, different sets of 20 PEQ Presets. The
nine Setups in the unit however share the same 20 PEQs.
Load Volume with Setup
On, Off, default Off. Setups can
be loaded with or without loading
the volume setting stored in the
Setup. Selecting Off the current
volume will not be changed.
Load
To load one of the nine Setups, click the Load button, then the desired Setup. The circle left to
the Setup name will change from white to orange color to signal the currently active Setup. Any
parameter change will let the circle become grey. This serves as indicator that the current state
no longer equals the stored Setup.
User's Guide ADI-2 Remote – v 1.0
17
Advertisement
Table of Contents
