Advanced Settings - RME Audio ADI-2 Remote User Manual

8.2.3 Advanced Settings

Width
Defines the stereo width. 1.00 equals full stereo, 0.00 mono, -1.00 swapped channels.
Crossfeed
OFF, 1, 2, 3, 4, 5. The Bauer ste-
reo to Binaural crossfeed effect
emulates speaker playback by re-
ducing the stereo width in the tre-
ble range. Adjustable in 5 steps.
DA Filter
Short Delay Sharp, Short Delay Slow, Sharp, Slow, SD LD (Short Delay Low Dispersion), Brick-
wall, NOS. The Digital to Analog Converter chip offers several oversampling filters. Default is
Sharp, offering the widest, most linear frequency response at lowest phase distortion. Slow
causes a small drop in the higher frequency range, but has a less aggressive (less steep) filter.
SD Sharp and SD Slow are similar, but have a lower latency and are minimum phase filters. NOS
is the filter with the lowest steepness and therefore affecting treble more than the others, but
offers the best impulse response.
Mono
OFF, ON, to Left. Default: OFF. The option to Left sends the sum of left and right channel to the
left output only.
Polarity
Inverts the phase (180°) on the corresponding channel.
M/S-Proc
Activates M/S processing. Monaural content is sent to the left, stereo to the right channel.
Loudness
ON, OFF. Default: OFF.
Bass Gain
Maximum Bass amplification. Adjustable from +1 dB to +10 dB in steps of 0.5 dB. Default: +7 dB.
Treble Gain
Max Treble amplification. Adjustable from +1 dB to +10 dB in steps of 0.5 dB. Default: +7 dB.
Low Vol Ref
Reference level for highest Bass/Treble amplification, referenced to the Volume set in dB. Avail-
able range is -90 dB to -20 dB. Default: -30 dB. A volume setting below this point will have maxi-
mum Bass/Treble gain, all volume settings above this point will have lower Bass/Treble gain. 20
dB above the Low Vol Ref setting the Bass/Treble gain will be zero.
Digital DC Protection
ON, OFF, Filter. Default: Filter. ON detects DC in the source signal and mutes the corresponding
analog output if DC is found too high. DC detection stays active with OFF but only issues a dif-
ferent warning message. Filter adds a High Pass to remove DC and infrasound.
De-Emphasis
Auto, OFF, ON. Default: Auto. For manually de-/activating the DAC's de-emphasis filter.
Loopback
OFF, Pre FX to 1/2 – 5/6, Post FX to 1/2 – 5/6, Post 1/2 – 5/6 -6 dB. Routes the current output
signal to the corresponding USB record channels.
User's Guide ADI-2 Remote – v 1.0
13