Hardware - RME Audio ADI-2 Remote User Manual

Hide thumbs Also See for ADI-2 Remote:

Table of Contents

8.4.4 Hardware

SPDIF In

Available settings are: Auto, Coax, Optical. Default: Auto.

SRC (Sample Rate Converter)

Available settings are: Off, AES In, SPDIF In. Default: SPDIF In. Note: In case a DoP signal (DSD)

is detected, SRC is automatically switched off.

SRC Gain

Available settings: 0 dB, -3 dB. Default: 0 dB. The SRC uses digital headroom to handle inter-

sample peaks up to +3 dBFS without distortion. With the -3 dB setting, an SRC signal with up to

+3 dBFS can be recorded via USB without distortion, or passed on at the AES/SPDIF output in

Dig Thru mode. A normal SRC input signal with 0 dBFS then has a level of -3 dBFS for these two

paths.

Optical Out

Available settings are: SPDIF, ADAT. While the input adapts to the received signal automatically,

the output needs to be switched manually. In Dig Thru mode with an ADAT signal received, the

output is switched to ADAT automatically with all 8 input channels passed through.

Remap Keys

OFF, ON, Remote. Default: Re-

mote. Allows to assign up to 64

different functions/actions to the

four function keys on the device

and seven programmable keys

on the remote, configurable via

the following seven entries:

VOL Key, I/O Key, EQ Key, SETUP Key, I(nfra-red) R(emote) Key 5-7.

Available functions/actions:

Setup 1 to 9, Mono 1/2, Mono 3/4, Mono 1/2 to L, Mono 3/4 to L, Mute 1/2, Mute 3/4, Mute all,

Loudness 1/2, Loudness 3/4, EQ In 1/2, EQ Out 1/2, EQ Out 3/4, B/T Out 1/2, B/T Out 3/4,

EQ+B/T+Ld 1/2, EQ+B/T+Ld 3/4, Toggle Ph/Line, EQ+B/T+Ld 1-4, Polarity, Crossfeed 1-5, DA

SD Sharp, DA SD Slow, DA Sharp, DA Slow, DA SD LD, DA Brickwall, DA NOS, Toggle View,

DIM, Mono all, Mono all to L, Loudness all, EQ Out all, BT all, AutoDark, EQ Preset 1-9, RIAA

Mode +, RIAA Mode -, RIAA Mono B.

Additionally Source AES, Source SPDIF c, Source Optical, Source Analog, Source USB 1/2 are

available. In Basic Mode DAC - and only there - these realize a switching of the input to be mon-

itored on the device and via the remote control.

User's Guide ADI-2 Remote - v 1.0

Table of Contents