Table of Contents
Advertisement
42
en | Camera
To define a title for sectors:
1.
2.
3.
6.13
Miscellaneous
Fast address
This parameter allows the appropriate camera to be operated via the numerical address in the
control system. Enter a number between 0000 and 9999, inclusive, to identify the camera.
Thermal FastAddress
Enter the number (between 0000 and 9999, inclusive) that corresponds to the numerical
address of the thermal camera in the control system. The default value is 1.
6.14
Wiper/Washer
Wiper
Controls the wiper of the MIC cameras. Options are:
–
–
–
–
Wiper/washer
Click Start to start the wiper/washer. Click Stop to stop the wiper/washer.
6.15
Audio
Audio
You can set the gain of the audio signals to suit your specific requirements. The live video
image is shown in the window to help you check the audio source. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio transmission on the 'Live'
functions page. For other connections, the transmission depends on the audio settings of the
respective system.
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data is encoded according to the selected format and requires
additional bandwidth. If you do not want any audio data to be transmitted, select Off.
Input volume
Set the input volume using the slide. Values range from 0 to 236.
Line Out
Set the line output gain using the slider. Values range from 0 to 143.
Recording format
Select a format for audio recording. The default value is AAC 48 kbps. You can select AAC 80
kbps, G.711 or L16 depending on the required audio quality or sampling rate.
AAC audio technology is licensed by Fraunhofer IIS.
(http://www.iis.fraunhofer.de/amm/)
2017.11 | 0.20 | F.01U.349.011
Place the cursor in the input box to the right of the sector number.
Type a title for the sector, up to 20 characters long.
To blank the sector, click the check box to the right of the sector title.
Off: Turns off the wiper.
On: Wiper wipes continuously until deactivated manually, or until it has been on for five
minutes (after which the camera will stop the wiper automatically).
Intermittent: Wipes twice, then stops. Every 15 seconds, this cycle repeats until users
select another option in this field.
One shot: Wipes five times, then turns off.
User Manual
MIC IP fusion 9000i
Bosch Security Systems
Advertisement
Table of Contents
