Changing Parameter Settings Or Values; Verifying Parameter Changes: Verify Menu - YASKAWA CIMR-JB Series Installation & Start-Up Manual

4.3 The Drive and Programming Modes
u

Changing Parameter Settings or Values

This example explains changing C1-01 (Acceleration Time 1) from 10.0 seconds (default) to
20.0 seconds.
1. Turn on the power to the drive. The initial display appears.
2.
Press the
3.
Press the
4.
Scroll through parameters by pressing the
appears.
5.
Press to view the current setting value (10.0). (Number
farthest to the left flashes)
6.
Press until the desired number is selected. ("1" flashes)
7.
Press the
8.
Press and the drive will confirm the change.
9. The display automatically returns to the screen shown in Step 4.
10.
Press the
u

Verifying Parameter Changes: Verify Menu

The Verify Menu lists edited parameters from the Programming Mode. The Verify Menu
helps determine which settings have been changed, and is particularly useful when replacing
a drive. If no settings have been changed the Verify Menu will read
also allows users to access and re-edit edited parameters.
Note: The Verify Menu will not display parameters from the A1 group even if those parameters have been
changed from default settings.
The following example is a continuation of the steps beginning on page 90. Here, parameter
C1-01 is accessed using the Verify Menu and is changed again to 20.0 s.
To check the list of edited parameters:
90
Step
key until the Setup Mode Screen appears.
key to view the parameter setting display.
key and enter 0020.0.
key until back at the initial display.
YASKAWA ELECTRIC TOEP C710606 25D YASKAWA AC Drive J1000 Installation & Start-Up Manual
key until C1-01
Display/Result
. The Verify menu