11
SERVICE WORK ON THE CHASSIS
11.12
Installing the lower triple clamp
x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
401540-10
–
Position the upper triple clamp with the steering.
–
Mount screw
101783-10
–
Position the fork legs.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
Position bleeder screws
101784-10
–
Fully tighten screws
Guideline
Screw, bottom triple clamp
101785-10
–
Tighten screw
Guideline
Screw, top steering head
101786-10
p. 96)
and O-ring
.
2
3
but do not tighten yet.
4
toward the front.
5
.
6
.
4
is correctly positioned.
1
M8
12 Nm (8.9 lbf ft)
M20x1.5
12 Nm (8.9 lbf ft)
38