15
COOLING SYSTEM
15.5
Refilling coolant
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and con-
tact a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immedi-
ately. Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
–
Position the motorcycle upright.
–
Place a suitable container under the water pump cover.
–
Remove screw
–
Completely drain the coolant.
–
Mount and tighten screw
Guideline
Screw, water pump cover
101819-10
x
–
Make sure that screw
–
Position the motorcycle upright.
–
Pour coolant in up to measurement
Guideline
Dimension
Coolant
–
Mount the radiator cap.
–
Take a short test ride.
–
Check the coolant level. (
101820-10
. Take off radiator cap
1
with a new seal ring.
1
is tightened.
1
above the radiator fins.
A
over the radiator fins
A
1.2 l (1.3 qt.)
p. 73)
.
2
M6
10 Nm (7.4 lbf ft)
10 mm (0.39 in)
Coolant (
p. 94)
Coolant (mixed ready to use) (
74
p. 94)