11
SERVICE WORK ON THE CHASSIS
11.9
Removing the fork protector
11.10
Installing the fork protector
11.11
Removing the lower triple clamp
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
Main work
–
Remove screws
–
Remove the screws on the right fork leg. Remove the fork protector from above.
B00306-10
x
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
B00306-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
x
Preparatory work
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove the front fender. (
–
Remove the handlebar cushion.
Main work
–
Remove screw
–
Remove screw
–
Take off the top triple clamp with the handlebar and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
101781-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
101782-10
(
p. 65)
x
(
p. 36)
x
on the left fork leg. Remove the fork protector from above.
1
(
p. 36)
x
(
p. 65)
x
(
p. 65)
x
(
p. 36)
x
p. 41)
p. 41)
.
1
.
2
. Remove protective ring
3
p. 34)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 34)
.
4
37
.
1