16
TUNING THE ENGINE
16.1
Checking the play in the throttle cable
16.2
Adjusting the play in the throttle cable
–
Check the throttle grip for smooth operation.
–
Move the handlebar to the straight-ahead position. Move the throttle grip back-
wards and forwards to ascertain the play in the throttle cable.
Throttle cable play
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
Danger
400192-10
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
x
Preparatory work
–
Remove the seat. (
–
Remove the fuel tank.
–
Check the throttle cable routing. (
Main work
–
Move the handlebar to the straight-ahead position.
–
Push back sleeves
–
Loosen nut
–
Loosen nut
the throttle grip.
Guideline
Throttle cable play
101821-10
–
Tighten nut
–
Press and hold the throttle grip in the closed setting. Turn adjusting screw
until there is no play in the throttle cable
–
Tighten nut
–
Push sleeves
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the play in the throttle cable. (
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
p. 44)
(
p. 48)
x
p. 54)
.
1
. Turn adjusting screw
2
3
. Turn adjusting screw
4
5
.
4
.
2
on. Check the throttle grip for smooth operation.
1
(
p. 49)
x
p. 44)
3... 5 mm (0.12... 0.2 in)
(
p. 75)
x
x
(
p. 75)
in as far as possible.
so that there is play in the throttle cable at
3... 5 mm (0.12... 0.2 in)
.
6
p. 75)
75
out
3