Roland M-480 Quick Start Manual page 3

5.
Enable the wireless LAN function
Use cursor buttons and [ENTER] to check the "Enable Wireless LAN".
* You can only use the wireless LAN function when the "Enable Wireless LAN" is checked.
fig.check-enable-LAN.eps
6.
Call up the WIRELESS LAN SETUP popup
Move the cursor to the SETUP button and press [ENTER]. You can call up the WIRELESS LAN SETUP popup.
fig.wireles-LAN-setup.eps
7.
Call up the WPS popup
Press [F2 (WPS)] to call up the WPS popup.
fig.WPS-popup.eps
8.
Operate the WPS of your wireless LAN access point
For example, press the [WPS] button of your wireless LAN access point.
* For details on WPS operation, refer to the documentation for your wireless LAN access point.
9.
Connect the M-480 to the Wireless LAN
Press [F8 (OK)] of the M-480. When it is successfully connected, the "CONNECTED" message appears in the WIRELESS LAN SETUP
popup.
* The connection data is stored in memory when you perform the WPS procedure; the device will automatically connect to the wireless network
the next time.
Be careful of the following points when you perform wireless LAN connection.
• The device (iPad) running the app must be connected to the same network.
• All connection data will be erased if you perform a factory reset or replace the internal lithium battery.
• The project file saved to the USB memory does not contain the connection data.
Functionality Added in M-480 Ver. 1.6
3