Table of Contents
Advertisement
Change setpoint
When you activate certain settings, the
display shows selection buttons and
you can change the set value.
Press the selection buttons
▶
→ Page 24 .
The display shows the set value.
6 Before first use
B prepare the appliance for use
use.
6.1 Start wash cycle without
laundry
Your appliance has been thoroughly
checked before leaving the factory. To
remove any residual water, wash
without any laundry for the first time.
Press .
1.
The power-on process takes a few
seconds.
The programCotton 90°Cor select the
2.
drum cleaning program in the
Home Connect app.
Close the door.
3.
Pull out the detergent drawer.
4.
Fill powder detergent into
5.
compartment II.
To avoid foaming, use only half the
amount recommended by the
detergent manufacturer for light
soiling. Do not use wool or delicate
detergent.
Slide the detergent drawer into the
6.
appliance.
To start the program, press .
7.
aThe display shows the remaining
program duration.
aAfter program end it shows
display:End.
Start the first wash or press , to put
8.
the appliance in standby mode.
→ "Essentials of the Ministry",
Page 32
usageNL
21
Advertisement
Table of Contents
