Table of Contents
Advertisement
en Before using for the first time
Changing a setting value
If you activate certain settings, the
display shows selection buttons and
you can change the setting value.
Press the selection buttons
▶
→ Page 23.
The display shows the setting
value.
Before using for the first time
6 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Press .
1.
The switch-on process takes a few
seconds.
Select the Cottons 90°C pro-
2.
gramme or the drum cleaning pro-
gramme in the Home Connect
app.
Close the door.
3.
Pull out the detergent drawer.
4.
20
Add washing powder containing
5.
oxygen bleach to compartment II.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press
to start the programme.
7.
a The display shows the remaining
programme duration.
a After the programme has ended,
the display shows: End.
Start the first wash cycle or press
8.
to put the appliance in standby
mode.
→ "Basic operation", Page 31
Advertisement
Table of Contents
