Table of Contents
Advertisement
NLSet up and connect
NB!
Freezing residual water in the device
can damage the device.
Do not place and use the device in
▶
frost-sensitive places or outdoors.
If the device is tilted more than 40°,
residual water can escape from the
device and cause material damage.
Carefully tilt the device.
▶
Transport the device upright.
▶
Place of installation
Holder
Floor with wooden
beams
Kitchenette
On a wall
14
Requirements
The device with
locking tabs
→ Page 31
to confirm.
Place the device
count on a
resistant
wooden plate (thick
too minimal
30mm) which
screwed firmly
to the floor.
The device al-
borrow under one
continuous work
place sheet,
that with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
No mains connection
cable and none
snakes in between
w
a
a-
nd and app
ra
a
and.
t clamp
4.4 Remove transport
protection devices
The device is secured for transport
with transport locks on the back of the
device.
Remark:Keep the bolts of the
transport protection devices and the
sleeves for later transport.
→ "Install transport protection", page
54
Pull the hoses out of the holders.
1.
Loosen and remove all bolts of the 4
2.
transport protection devices with
an open-end wrench SW13
.
Advertisement
Table of Contents
