Table of Contents
Advertisement
NLSet up and connect
Connect the water inlet hose to the
2.
tap (26.4 mm = 3/4").
Carefully open the tap and check
3.
that the connections are tight.
Water outlet connection types
The information will help you connect this
appliance to the water outlet.
NB!
When draining, the water drain hose is
under pressure and can become detached
from the installed connection position.
▶
Secure the water drain hose against
unintentional loosening.
Remark:Observe the pumping
heights.
The maximum pumping height is
100 cm.
Siphon
Washbasin
16
The connection position
tie with one
hose clamp
(24-40 mm) Bore
gene.
The water
feeding hose with
a bend
→
Page 31
fix
honor and
ge
n.
plastic stand
pipe with rubber
run muff or one
floor drain
4.6 Adjusting the device
To reduce noise and vibrations and
avoid the device walking, set the
device horizontally.
Loosen the lock nuts with a SW17
1.
open-end wrench.
The water
feeding hose with
a bend
→ Page 31
fix and bor-
gene.
Advertisement
Table of Contents
