Table of Contents
Advertisement
en Before using for the first time
To align the appliance, turn the ap-
2.
pliance feet. Check that the appli-
ance is level using a spirit level.
All appliance feet must stand firmly
on the ground.
Use a WAF 17 wrench to tighten
3.
the lock nuts against the housing
until they are hand-tight.
In doing so, hold the foot tight and
do not adjust its height.
16
Before using for the first time
5 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Turn the programme selector to
1.
Drum Clean .
Close the door.
2.
Pull out the detergent drawer.
3.
Pour approx. 1 litre of tap water
4.
into compartment II.
Advertisement
Table of Contents
